214685
50
Revision A
Figure 4.43: Flighting Stretched Axially
20. Stretch flighting (A) to fit auger tube as shown. Use
slotted holes on flighting to get the best fit around the
auger tube.
Figure 4.44: Left Side of Auger
21. With flighting in the desired position, mark hole
locations (A) on auger tube.
22. Remove the flighting (B) from auger, and drill 11 mm
(7/16 in.) holes at the marked locations (A) on
auger tube.
23. Remove nearest access cover(s). Retain for
reinstallation.
24. Install the bolt-on flighting (B) using two button head
bolts and nuts at location (C), and four flange head bolts
and nuts at locations (A).
IMPORTANT:
Ensure bolt heads at location (C) are on the inboard
(crop side) and nuts are on the outboard side of the
flighting.
25. Repeat Steps
to
for the
remaining flighting on the left side of the auger.
Figure 4.45: Right Side of Auger
26. Place bolt-on flighting (A) outboard of the other
flighting (B) on the right side of the auger as shown.
27. Temporarily secure bolt-on flighting (A) with two button
head bolts and nuts at location (C).
28. Repeat Steps
to
for both
pieces of flighting on the right side of the auger.
29. Install flighting slot plugs (MD #213084) in the flighting
mounting locations and secure with M6 bolts and
tee nuts.
30. Torque all nuts and bolts to 47 Nm (35 lbf·ft) to eliminate
deflection on flighting, then retorque them to 58
–
64 Nm
(43
–
47 lbf·ft).
NOTE:
The flighting should fit tightly against the auger tube; however, gaps are not uncommon. Crop material may collect
in these gaps, but this should not affect performance. If desired, use silicone sealant to fill these gaps.
Summary of Contents for FlexDraper FD1 Series
