MacDon FlexDraper FD1 Series, Unloading And Assembly Instructions

Page: 57 / 354

214685
45
Revision A
4.2.6 Converting from Ultra Narrow or Narrow Configuration to Wide
Configuration
One kit of MD #287031 4 is required to convert to this configuration. Two flighting plugs (MD #213084), two M6 hex
head bolts (MD #252703), and two M6 tee nuts (MD #197263) are recommended to close the flighting mounting
locations. These parts can be ordered from a MacDon Dealer.
Figure 4.31: Auger Configurations (Rear View)
1 - Narrow Configuration 2 - Ultra Narrow Configuration
3 - Wide Configuration
The Narrow, Ultra Narrow, and Wide auger configurations
are shown at right. When converting from Narrow or
Ultra Narrow configuration to Wide configuration, you will
need to replace the existing flightings (A).
NOTE:
Some parts have been removed from the illustrations for
clarity.
1. If necessary to improve access and ease installation, remove float module from combine. For instructions, refer
to the header operator
’
s manual or technical manual.
Figure 4.32: Narrow Configuration (Right Side)
2. Remove bolts (A) and access cover (B) from the right
side of the auger. Retain for later reassembly.
3. Remove hardware (C) and bolt-on flighting (D) from the
right side of the auger. Discard flighting, but retain
hardware to attach the new flighting.
4. Remove flighting slot plug, bolt, and tee nut (E). Retain
for later reinstallation.
NOTE:
Only two flighting slot plugs (E) should be removed
—
one from each outboard side of the auger.
5. Repeat Step 2, page 45 and Step 3, page 45 for the
remaining bolt-on flighting(s).
SETTING UP FLOAT MODULE
4. MD #287031 contains wear-resistant flightings, and is available only through MacDon Parts.