MacDon FlexDraper FD1 Series, Unloading And Assembly Instructions

Page: 51 / 354

214685
39
Revision A
1. If necessary to improve access and ease installation, remove float module from combine. For instructions, refer
to the header operator
’
s manual or technical manual.
Figure 4.18: Wide Configuration (Right Side)
2. Remove bolts (A) and remove the access cover (B) on
the right side of the auger. Retain for later reassembly.
NOTE:
If necessary, remove multiple access covers for ease of
access.
3. Remove and discard the two flighting slot plugs (C) on
the right side of the auger.
Figure 4.19: Medium Configuration (Right Side)
4. Install bolt-on flighting (A) on the right side of the auger
as shown, and secure with six carriage head bolts and
six nuts at locations (B).
IMPORTANT:
Bolt heads must be installed on inside of auger to
prevent damage to internal components.
5. Torque all nuts and bolts to 47 Nm (35 lbf·ft) to eliminate
deflection on flighting, then torque them to 58
–
64 Nm
(43
–
47 lbf·ft).
Figure 4.20: Medium Configuration (Left Side)
6. Repeat Step 2, page 39 and Step 3, page 39 at the left
side of auger.
7. Install bolt-on flighting (A) on the left side as shown, and
secure with six carriage head bolts and six nuts at
locations (B).
IMPORTANT:
Bolt heads must be installed on inside of auger to
prevent damage to internal components.
8. Torque all nuts and bolts (B) to 47 Nm (35 lbf·ft) to
eliminate deflection on flighting, then torque them to
58
–
64 Nm (43
–
47 lbf·ft).
9. Remove extra auger fingers. A total of 22 fingers are
recommended for this configuration. Refer to
4.2.11
Removing Feed Auger Fingers, page 56 .
SETTING UP FLOAT MODULE