![background image](http://html.mh-extra.com/html/macdon/flexdraper-fd1-series/flexdraper-fd1-series_operators-manual_685695419.webp)
7. Tension the draper.
Locate adjuster bolt (A) and
follow the directions on the decal for the proper draper
tensioning or refer to
5.12.3 Adjusting Draper Tension,
.
8. Disengage the reel and header safety props.
9. Start the engine and lower the header and reel.
10. Run the machine to verify the draper tracks correctly.
Refer to
5.12.4 Adjusting Header Draper Tracking,
if further adjustment is necessary.
Figure 5.194: Draper Tensioner
5.12.7
Replacing Draper Deflectors
Removing Narrow Draper Deflectors
Narrow draper de
fl
ectors can replace wide de
fl
ectors if bunching occurs at the ends of the header when decks
are set for center delivery.
DANGER
To avoid bodily injury or death from unexpected start-up or fall of a raised machine, always stop engine
and remove key before leaving the operator’s seat, and always engage safety props before going under
the machine for any reason.
1. Raise the reel to its full height and lower the header to the ground.
2. Shift the decks to create a work space at one end of the header if hydraulic deck shift is installed; otherwise,
move the decks manually after shutting down the combine.
3. Stop the engine, remove the key, and engage the reel safety props.
4. Open the endshield. Refer to
5. Remove two Torx
®
head screws (A) and lock nuts.
6. Remove three carriage bolts (B) and lock nuts and
remove the aft de
fl
ector (C).
Figure 5.195: Aft Deflector
147831
401
Revision A
Summary of Contents for FlexDraper FD1 Series
