8. Set the deck (A) to a gap (B) of 1 mm + measurement
noted in Step
below the cutterbar (C) to
create a seal.
9. Tighten the deck support hardware (D).
10. Recheck the gap (B) to ensure it is properly set. Refer
to Step
11. Tension the draper. Refer to
.
Figure 5.176: Deck Support
12. Adjust the backsheet de
fl
ector (A) (if required) by
loosening nut (D) and moving the de
fl
ector until there
is a 1/32–5/16 in. (1–7 mm) gap (C) between the
draper (B) and the de
fl
ector.
Figure 5.177: Backsheet Deflector
147831
393
Revision A
Summary of Contents for FlexDraper FD1 Series
