NOTE:
Some parts are removed from the illustration for clarity.
1. Remove bolts (A) and access cover (B) from the
right-hand side of the auger. Retain for reassembly.
2. Remove hardware (C) and bolt-on
fl
ighting (D) from the
auger.
3. Remove the discard the
fl
ighting slot plug (E) located
close to the end of the
fl
ighting (D).
4.
Converting from Configuration A:
Repeat above
steps for the other
fl
ighting.
Figure 4.15: Configuration C (RH Side)
5.
Converting from Configuration C:
Remove bolts (A),
access cover (B), and two
fl
ighting slot plugs (C) from
the right-hand side of the auger.
6. Repeat Steps
to
at the
left-hand side of the feed auger.
Figure 4.16: Configuration C (RH Side)
7. Install two bolt-on
fl
ightings (MD #213361) (A) on the
right-hand side as shown, and secure each
fl
ighting
with two button head bolts (MD #135723) and nuts at
location (B) and four carriage head bolts (MD #184657)
and nuts at location (C).
IMPORTANT:
Bolt heads at location (B) must be installed on
the crop side (inboard) and nuts on the outboard
of the
fl
ighting, while bolt heads at location (C)
must be installed on inside of auger to prevent
damage to internal components.
8. Torque all nuts to 35 ft
·
lbf (47 N
·
m) to eliminate
de
fl
ection on
fl
ighting, then torque all nuts and bolts
on
fl
ighting to 43–47 ft
·
lbf (58–64 N
·
m).
9. Install
fl
ighting slot plug at location (D) from inside
the auger. Repeat for the other
fl
ighting mounting
locations.
Figure 4.17: Configuration B (RH Side)
147831
231
Revision A
Summary of Contents for FlexDraper FD1 Series
