214325
82
Revision A
Figure 3.159: Strap on Center Frame
1.
Remove two bolts (A) and remove strap (B) from both
sides of center frame.
NOTE:
If strap is difficult to remove, lift on one end of header to
release load on strap so that bolts can be removed.
Figure 3.160: Shipping Brace
2.
Remove lynch pin (A), nut and bolt (B), and remove
shipping brace (C).
3.
Reinstall lynch pin (A).
3.4.4
Positioning Transport Lights
Transport lights are located on each outboard reel arm.
Figure 3.161: Transport Light
1.
Position light (A) perpendicular to header. Light arm
should move with normal hand force yet maintain its
position. If not, proceed to next step.
2.
Loosen jam nut (B) on light attachment bolt, and adjust
hex nut (C) as required. Tighten jam nut (B).
3.
Repeat above for opposite side.
