MacDon D65, Operator'S Manual

Page: 142 / 310

214327
122
Revision B
5.3 Maintenance Requirements
Regular maintenance is the best insurance against early wear and untimely breakdowns.
Periodic maintenance requirements are organized according to service intervals.
When servicing the machine, refer to the appropriate section in this chapter and use only the fluids and lubricants specified
in Recommended Fluids and Lubricants on the inside back cover.
Log hours of operation, use the maintenance record, and keep copies of your maintenance records (refer to 5.3.1
Maintenance Schedule/Record, page 122 ).
CAUTION
Carefully follow safety messages. Refer to 5.1 Preparing Machine for Servicing, page 119 and 1 Safety, page 1 .
5.3.1 Maintenance Schedule/Record
Maintenance requirements are organized according to service intervals.
If a service interval specifies more than one timeframe, e.g., "100 hours or annually", service the machine at whichever
interval is reached first.
IMPORTANT:
Service the machine more often if operating under adverse conditions (severe dust, extra heavy loads, etc.).
Maintenance
Record
Action:
ü ü
- Check
SS
- Lubricate
▲▲
- Change
Hour Meter Reading
Date
Serviced by
First Use, refer to 5.3.2 Break-In Inspection, page 123
End of Season, refer to 5.3.4 Maintaining the Header
–
End-of-Season, page 124
10 Hours or Daily 46
ü
Hydraulic hoses and lines 47
ü
Knife sections, guards, and
hold-downs
47
ü
Tire pressure
47
S
Knife (except in sandy
conditions)
47
25 Hours
S
Knifehead(s)
47
50 Hours
ü
Draper roller bearings
▲
Knife drive box oil - first 50
hours only
S
All upper cross auger (UCA)
grease points
100 Hours or Annually 46
MAINTENANCE AND SERVICING
46. Whichever occurs first.
47. A record of daily maintenance is not required, but can be kept at the Owner
’
s/Operator
’
s discretion.