169784
41
Revision H
3.10
Installing Wheels
To install the wheels, follow these steps:
1001277
2
3
4
5
6
1
Figure 3.58: Wheel Bolt Tightening Sequence
1.
Attach the four wheels to hubs with bolts provided in hubs.
2.
Torque wheel bolts to 110
–
120 Nm (80
–
90·lbf·ft). Refer to
bolt tightening sequence illustration at right.
3.
Check tire inflation pressure. Inflate to 448 kPa (65 psi).
IMPORTANT:
Do not exceed maximum pressure specified on tire
sidewall.
NOTE:
Height adjustment procedures for stabilizer wheels in field
mode are provided in your header operator
’
s manual.
Summary of Contents for D65
