169784
27
Revision H
3.5
Rear Suspension and Right Side Tow-Bar Cradle
The procedure for installing the rear suspension and the right side tow-bar cradle varies depending on the header type and
width. See the appropriate procedure below:
•
•
3.5.1
Installing Rear Suspension and Right Tow-Bar Cradle on a 9.1 Meter (30 Foot)
D65 Windrower Header
To install the rear suspension and right tow-bar cradle, follow these steps:
1011572
A
Figure 3.26: Right Header Leg
1.
Loosely install four 3/8 NC x 1 in. carriage bolts (A)
(MD #100456) at the base of the vertical leg. Install bolts
from inside leg.
1011577
A
B
C
D
E
C
Figure 3.27: Right Header Leg
2.
Lift axle (A) and channel/spring subassembly (B), and
position lower end of subassembly (B) into leg.
3.
Position lower end of subassembly (B) on bolts (C).
4.
Slide subassembly (B) into leg.
5.
Fasten subassembly to leg at location (C) with four flange
nuts (MD #30228).
6.
Attach top of subassembly (B) to leg with two
3/8 NC x 3/4 in. carriage bolts (D) and smooth face lock
nuts in right of leg, and two 3/8 NC x 1 in. carriage bolts (E)
(MD #100456) and smooth face lock nuts (MD #30228) in
left of leg. Install bolts from inside leg. Tighten all hardware
except bolts (E).
Summary of Contents for D65
