MacDon D1X Series, Operator'S Manual, Page: 72 / 274

OPERATION
6. Position crop divider as shown by inserting lugs (A) into
holes in endsheet.
7. Lift forward end of crop divider until pin (B) at top of
crop divider engages and closes latch (C).
8. Push safety lever (D) downwards to lock pin into
latch (C).
Figure 3.40: Crop Divider
9. Pull the tip of the crop divider to ensure there is no
lateral movement. If necessary, adjust bolts (A) to
tighten crop divider and eliminate lateral movement.
10. Close or install endshields. Refer to
3.2.3 Endshields,
page 31
.
Figure 3.41: Crop Divider
Installing Crop Dividers without Latch Option onto Header
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason.
1. Lower reel and raise header. Refer to your windrower operator’s manual for instructions.
2. Stop engine and remove key.
3. Engage safety props. Refer to your windrower operator’s manual for instructions.
4. Open or remove endshields. Refer to
3.2.3 Endshields, page 31
.
214044
60
Revision A