4. Open endshield. Refer to
5. Loosen nuts (A) on cutterbar until retainer (B) is loose.
Figure 5.142: Deflector Retainer
6. Remove fasteners securing de
fl
ector to endsheet.
Nuts (A) are accessible from the side of the endshield,
and nuts (B) on the uppermost fasteners are accessible
from behind de
fl
ector (C).
7. Remove de
fl
ector (C).
Figure 5.143: Wide Deflector
8. Remove bolts (A) and remove de
fl
ector support (B).
9. Replace lower bolt (A) (if not reinstalling support [B]) to
secure belt guide (C) to opposite side of endsheet.
10. Repeat for opposite end of header.
Figure 5.144: Deflector Support
Installing Wide Draper Deflectors
DANGER
To avoid bodily injury or death from unexpected start-up or fall of a raised machine, always stop engine
and remove key before leaving the operator’s seat, and always engage safety props before going under
the machine for any reason.
214044
171
Revision A