215184
374
Revision A
1010068
C
D
A
B
E
Figure 9.154: CLAAS Combine Controls
7.
Press OK key (E), and use < key (C) or > key (D) to select the
REEL FORE AND AFT window.
8.
Use
–
key (A) or
+
key (B) to set the reel fore-aft position.
NOTE:
Control handle button (A) or button (B) (as shown in
Figure
) can also be used to set the reel
fore-aft position.
1003744
A
B
Figure 9.155: CLAAS Control Handle Buttons
9.
Press and hold button (A) or button (B) for 3 seconds to
store the setting into the CEBIS (an alarm will sound when
the new setting has been stored).
NOTE:
Whenever button (A) or button (B) is pressed for 3 seconds,
the current positions for reel speed and cutting height are
stored.
9.1.10
CLAAS 600 and 700 Series Combines
Calibrating the Auto Header Height Control
–
CLAAS 600 and 700 Series
For best performance of the auto header height control (AHHC), perform these procedures with the center-link set to
D
.
When setup and calibration are complete, adjust the center-link back to desired header angle. For instructions, refer to
Header Angle in the header operator
’
s manual for instructions.
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the combine
operator
’
s manual for updates.
NOTE:
If header float is set too light, it can prevent AHHC calibration. You may need to set the float heavier for calibration
procedure so header doesn
’
t separate from the float module.
1.
Ensure center-link is set to
D
.
2.
Ensure that the header float is unlocked.