MAC215986
61
Revision A
1001143
A
B
Figure 3.58: Header on Combine
13. Lower feeder house (A) until the feeder house disengages
float module support (B).
14. Back the combine slowly away from the header.
Feeder Deflectors
–
New Holland CR Series Combines
On New Holland CR Series combines, feeder deflectors may need to be installed. Feeder deflectors are
NOT
necessary on
New Holland CX Series combines.
For New Holland CR combines only:
Wide feeder deflectors have been factory-installed on the float module to improve
feeding into the feeder house. Remove the feeder deflectors if necessary. For instructions, refer to
Deflectors on New Holland CR Combines, page 396
Long feeder kits are provided for narrow feeder house combines and can be installed to replace the short feeder
deflectors.
Table 3.2 FM200 Feeder Kits for CR Model Combines
Feeder House Size
Feeder Kit Size
Part Number
1250
–
1350 mm (49
–
65 in.)
Narrow: 200 mm (7 7/8 in.)
MAC328082, 328083
1100 mm (43 1/2 in.) and below
Wide: 325 mm (12 13/16 in.)
MAC314690, 314691
3.6.2
Attaching Header to / Detaching Header from FM200 Float Module
To attach the float module to, or detach it from, the header, follow the relevant procedure. These procedures require that
the float module remain attached to the combine.
NOTE:
If the header is equipped with transport wheels, the float module can be attached to and detached from the header while
it is in either transport or field mode.
Detach the float module from the header only in the following cases:
•
The header is needed for use on a windrower
•
A different, float module-compatible header will be attached to the combine
•
The header or float module need service or repair, and the service or repair procedures require that the float module
be detached from the header
