MAC215986
40
Revision A
ϭϬϯϵϭϬϭ
B
C
A
E
D
Figure 3.19: Endshield Alignment
–
View from Inside
the Deck
5.
Check gap (A) at the bottom front of left neck shield (E) to
the edge of the end panel. The gap range is
2
–
4 mm (0.09
–
0.16 in).
6.
Check gap (B) at front of left neck shield (E) to the inside
edge of endshield (D). The gap range is
42
–
52 mm (1.7
–
2.04 in).
7.
Check gap (C) at rear of left neck shield (E) to the inside
edge of endshield (D). The gap range is
15
–
25 mm (0.68
–
1 in).
ϭϬϯϴϵϱϱ
A
B
C
D
Figure 3.20: Two-Stage Latch
8.
Check that bolt (A) is fully engaged on two-stage latch (B)
to prevent the header endshield from opening during
operation.
NOTE:
The header endshield is shown transparent in the
illustration.
9.
If adjustment is required, loosen nuts (D) and slide
bracket (C) up or down.
10. Once complete, tighten nuts (D) and check Steps
to
again.
Removing Header Endshields
Remove the endshields when servicing the end shields.
1028869
A
B
C
C
Figure 3.21: Left Header Endshield
1.
Fully open the header endshield. For instructions, refer to
Opening Header Endshields, page 35
2.
Engage latch (A) to prevent any endshield movement.
3.
Remove self-tapping screw (B).
4.
Slide the header endshield upwards and remove it from
hinge arm (C).
5.
Place the header endshield away from the work area.
