MacDon CASE IH FlexDraper FD225, Manual

Page: 402 / 560

MAC215986
378
Revision A
ϭϬϯϴϯϴϮ
A B
C
C
A
A
Figure 4.193: Drive Roller
–
Bearing End
4. Install two bolts (A) into the feed deck.
5. Install both covers (B) onto the two bolts.
IMPORTANT:
Position the covers in the order shown.
6. Secure the drive roller bearing housing using two nuts (D).
7. Install the feed deck draper. For instructions, refer to 4.10.1
Replacing Feed Draper, page 370 .
8. Tension the feed draper. For instructions, refer to 4.10.2
Checking and Adjusting Feed Draper Tension, page 373 .
Removing Feed Draper Drive Roller Bearing
The feed draper drive roller bearing helps the roller turn. The bearing needs to be removed when replacing it.
DANGER
To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and
remove the key before leaving the operator
’
s seat, and always engage the safety props before going under the
machine for any reason.
1. Raise the reel fully.
2. Raise the header fully.
3. Shut down the engine, and remove the key from the ignition.
4. Engage the reel safety props. For instructions, refer to Engaging Reel Safety Props, page 33 .
5. Engage the header
’
s safety props. For instructions, refer to the combine operator
’
s manual.
MAINTENANCE AND SERVICING