MAC215986
370
Revision A
4.10
Feed Deck
The feed deck is located on the FM200 Float Module. It consists of a motor and feed draper that conveys cut crop to the
feed auger.
4.10.1
Replacing Feed Draper
Replace the feed draper if it is torn, cracked, or missing slats.
DANGER
To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and
remove the key before leaving the operator
’
s seat, and always engage the safety props before going under the
machine for any reason.
1.
Raise the header fully.
2.
Raise the reel fully.
3.
Shut down the engine, and remove the key from the ignition.
4.
Engage the header
’
s safety props. For instructions, refer to the combine operator
’
s manual.
5.
Engage the reel safety props. For instructions, refer to
Engaging Reel Safety Props, page 33
.
ϭϬϯϴϰϵϴ
A
A
A
B
A
B
C
D
Figure 4.174: Draper Seal
6.
To access the draper: Remove five countersunk screws (A)
and retainer (B). Remove one button head screw and
washer (C). Flip mid-filler (D) over. Repeat this step on the
opposite side of the feed deck.
B
1027877
A
Figure 4.175: Feed Draper Tensioner
7.
To release the draper tension, loosen jam nut (A) and turn
bolt (B) counterclockwise. Repeat at the opposite side of
the header.
