MAC215986
269
Revision A
p
Header drive completion gearbox lubricant;
refer to
p
Hydraulic oil; refer to
4.2.2
Break-In Inspection
Break-in inspection involves checking belts, fluids, and performing general machine inspections for loose hardware or other
areas of concern. Break-in inspections ensure that all components can operate for an extended period without requiring
service or replacement. The break-in period is the first 50 hours of operation after the machine
’
s initial start up.
Inspection
Interval
Item
Refer to
5
Minutes
Check hydraulic oil level in reservoir
(check after first run-up and after the
hydraulic hoses have filled with oil).
4.4.1 Checking Oil Level in Hydraulic Reservoir, page 292
5
Hours
Check for loose hardware and tighten to
required torque.
7.1 Torque Specifications, page 515
10
Hours
Check auger drive chain tension.
Checking Feed Auger Drive Chain Tension
10
Hours
Check knife drive box mounting bolts.
Checking Mounting Bolts, page 368
10
Hours
Grease the feed draper bearings.
50
Hours
Change float module gearbox oil.
Changing Oil in Header Drive Main Gearbox, page 287
50
Hours
Change float module hydraulic oil filter.
4.4.4 Changing Oil Filter, page 294
50
Hours
Change knife drive box lubricant.
Changing Oil in Knife Drive Box, page 368
50
Hours
Check gearbox chain tension.
and
