MAC215986
294
Revision A
4.4.4
Changing Oil Filter
Change the oil filter after the first 50 hours of operation and every 250 hours thereafter.
Obtain filter kit (MAC320360)
72
from your MacDon Dealer.
DANGER
To prevent injury or death from the unexpected start-up of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
1.
Shut down the engine, and remove the key from the ignition.
1029245
A
B
Figure 4.35: FM200 Integrated Pump
2.
Clean around the mating surfaces of filter (A) and
integrated pump (B).
3.
Place a suitably sized container (approximately 1 liter
[0.26 gallons]) under the filter to collect oil runoff.
4.
Twist-off filter (A) by hand and clean the exposed filter port
in the integrated pump.
5.
Apply a thin film of clean oil to the O-ring provided with the
new filter.
6.
Turn the new filter onto integrated pump (B) until the
O-ring contacts the mating surface. Tighten the filter an
additional 1/2 to 3/4 turn by hand.
IMPORTANT:
Do
NOT
use a filter wrench to install the new filter.
Overtightening can damage the O-ring and filter.
72. Part number MAC202986 is printed on the filter, but service the filter using kit MAC320360. The kit includes
installation instructions.
