214805
15
Revision A
3.6
Installing Tall Crop Divider Kit
If the Tall Crop Divider kit is
NOT
supplied, proceed to
3.7 Adjusting Lean Bar, page 16
. Otherwise, proceed as follows:
1009065
A
Figure 3.17: Lean Bar
1.
Unpack kit and disassemble hardware from divider.
NOTE:
If tall crop extension angles are not required, proceed to
Step
2.
Remove hardware (A) on both sides of the lean bar, and
then remove the lean bar from the auger header.
1008986
A
B
C
C
Figure 3.18: Extension Angles Attached to Ends of
Lean Bar
3.
Attach extension angles (A) to each end of lean bar (B) with
four 1/2 x 1.0 in. hex bolts (C) and nuts provided.
4.
Reinstall lean bar on header with existing hardware.
Tighten bolts.
1009062
A
B
C
D
Figure 3.19: Tall Crop Divider Installed
5.
Position left divider (C) at left side of lean bar and attach
with U-bolt (A), two 3/8 in. nuts, and two 1/2 x 1.0 in. hex
bolts (B) and nuts provided.
NOTE:
The divider may be positioned as shown or using the
optional mounting hole (D).
6.
Adjust to desired position and tighten hardware.
7.
Repeat the previous two steps for the right side.
