MacDon A40-D, Operator'S Manual

Page: 78 / 240

214804
64
Revision A
3.6.5 Setting Reel Position
Reel position has been found to be a critical factor in achieving good results in adverse conditions. Reel position is
factory-set for average straight standing crop. It can be adjusted both vertically and horizontally (fore-aft) for
different crop conditions.
See table below for recommended reel position in unusual crop conditions:
Crop Condition Reel Position
Crop down or lodged Forward and down (also increase reel speed)
Wet or dead material collects on cutterbar and plugs knife Back and down (close to guards)
Short crop Back
Thick stemmed or heavy standing Up and forward
To make adjustments to reel position, refer to the following sections:
•
Adjusting Reel Fore-Aft Position, page 64
•
Adjusting Reel Vertical Position, page 66
Adjusting Reel Fore-Aft Position
Figure 3.88: Measuring Reel Fore-Aft Offset
The reel fore-aft offset is factory-set to 816 mm (32 3/8 in.)
as measured from the inside edge of the reel tube to the
back frame member as shown in the illustration at right.
NOTE:
The reel must be adjusted equally on both sides.
CAUTION
To prevent accidental movement of windrower, return ground speed lever (GSL) to Park, center steering
wheel to lock, shut off engine, and remove key.
OPERATION