depressurize your marker, unscrew the ASA cap until you hear the air being vented from the cap. Your air
system is now turned off and safe to remove.
NOTE: WHEN YOU UNSCREW THE ASA CAP, YOUR MARKER MAY STORE ONE SHOT. POINT THE MARKER IN A
SAFE DIRECTION AND FIRE OFF THAT SHOT BEFORE ENTERING A SAFE AREA.
Using a loader
Your marker can operate using any commercially available loader. The software and beam sensor will
compensate for the speed of the hopper, ensuring that the marker fires as quickly as the loader allows.
Installing a loader onto your marker
Open the cam lever as shown. This should allow your loader neck to fit into the feed tube as shown. If your
loader does not fit into the feed tube, then you may have to loosen the cam lever – this is done by rotating
the cam lever counter clockwise; once your loader is pushed all the way down into the feed tube close the
cam lever. If your loader is loose, you may need to open the cam lever, and tighten it by turning clockwise to
adjust the cam system to hold your hopper tightly. Only ever adjust your cam lever by one turn at a time to
prevent over tightening.
Removing your loader
Open the clamp by swinging the lever on its hinge. This will loosen the loader and allow you to remove it
easily. If it does not remove easily, then it means that you have the cam lever over tightened.
DO NOT OVER TIGHTEN YOUR FEED CLAMP! OVERTIGHTENING MAY RESULT IN DAMAGE TO YOUR LOADER
OR CLAMP.
