MACDEV Cyborg RX, Owner'S Manual

Page: 14 / 17

TROUBLESHOOTING
If you are experiencing difficulties with your marker, please check this table first to see if there is an easy
solution listed. If at any time you are unsure about how to work on your marker, please contact a certified
MacDev technician or service centre.
Symptom Possible Cause Solution
Although a fresh battery
has been fitted, your
Cyborg will not turn on
The battery has not been fitted
correctly
Ensure that the battery is firmly con -
nected to both terminals. Ensure that the
positive (+) terminal is connected to the
positive terminal on your battery.
Your Cyborg leaks from
the solenoid
Leaking hammer switch o-ring Clean and relubricate the drivetrain with
particular attention to the hammer switch
o-ring. Replace if necessary.
Leaking manifold o-rings Check that the 3 manifold o-rings are in
place between the solenoid and subplate.
If they are damaged or missing, then
replace them.
Your Cyborg uses
excessive air
Dwell set too high Check the Dwell setting on your board. It
should be 8-10ms.
General leak Make certain that there are no leaks from
your fittings or air system wasting your air
supply.
Symptom Possible Cause Solution
Your Cyborg is
chopping paintballs
Beam sensor is turned off Always play with the beam sensor
enabled.
Beam sensor is dirty or blocked Clean the breach, bolt and sensor.
Loader is set on a force setting
too high for your paintballs
Some force fed loaders can apply enough
force to break a fragile paintball. If this is
the case, consult your loader manual to
reduce the force setting.
Detents are missing or incorrectly
installed
Replace or re-install your detents.
Your Cyborg will not fire The trigger is set up incorrectly Ensure that the trigger actuates the mi -
croswitch by adjusting the actuator screw.
The beam sensor is on, and there
are no paintballs loaded
Load some paintballs.
The solenoid is not plugged in Plug the solenoid into the board.
Your Cyborg fires high
on the first shot or
inconsistently.
Creeping inline regulator Clean and lubricate the inline regulator,
ensure that the seat and piston are in
good condition.
Your Cyborg fires low
on the first shot
Sticking drivetrain Clean and relubricate the drivetrain. If you
continue to have problems:
-increase the dwell by 1-2 ms.
-increase the ABS parameter on your
board.
26