Part No. 0706436 Rev A
ColorSpan CS54xx Exhaust Kit
Page 4 of 5
6.
Insert the original screws through the fan.
The screws should be inserted through the side of the fan that does not have a label as
shown below. The air flows in the direction of the fan’s label.
7.
Insert the fan screws through the enclosure and into the screw holes of the exhaust vent.
The exhaust vent should be oriented so that the vent will point up when the enclosure
installed on the printer.
8.
Tighten the four screws.
9.
Repeat the vent installation steps for both exhaust vents.
Installing the Top
Enclosure
10.
Secure the top enclosure to the printer using the original ten screws.
11.
Connect the power cables for both exhaust fans at their quick connect locations.
