# ping www.google.com
PING www.google.com (172.217.27.164): 56 data bytes
64 bytes from 172.217.27.164: seq=0 ttl=49 time=114.204 ms
64 bytes from 172.217.27.164: seq=1 ttl=49 time=113.781 ms
64 bytes from 172.217.27.164: seq=2 ttl=49 time=118.081 ms
64 bytes from 172.217.27.164: seq=3 ttl=49 time=113.781 ms
^C
--- www.google.com ping statistics ---
4 packets transmitted, 4 packets received, 0% packet loss
round-trip min/avg/max = 113.781/114.961/118.081 ms
USB Interface
There is one
USB 3.0
port available on the MACCHIATObin board, your may plug in either
USB3.0 stick or USB2.0 stick to this port. Example detection output from Buildroot when a
USB3.0 device is plugged in:
# [ 87.175751] usb 2-1: new SuperSpeed USB device number 2 using xhci-hcd
[ 87.297072] usb-storage 2-1:1.0: USB Mass Storage device detected
[ 87.303349] scsi host5: usb-storage 2-1:1.0
[ 88.367846] scsi 5:0:0:0: Direct-Access Kingston DataTraveler 3.0 PMAP PQ: 0 ANSI:
6
[ 89.343260] sd 5:0:0:0: [sda] 15364416 512-byte logical blocks: (7.87 GB/7.33 GiB)
[ 89.350981] sd 5:0:0:0: [sda] Write Protect is off
[ 89.355949] sd 5:0:0:0: [sda] No Caching mode page found
[ 89.361294] sd 5:0:0:0: [sda] Assuming drive cache: write through
[ 89.396108] sda: sda1
[ 89.399340] sd 5:0:0:0: [sda] Attached SCSI removable disk
Additionally, you can use
lsusb
command in the console to get information on devices
connected to USB buses:
# lsusb
Bus 002 Device 002: ID 0951:1666
Bus 001 Device 001: ID 1d6b:0002
Bus 002 Device 001: ID 1d6b:0003
Checking reset key
After you press the
Reset Button
on your MACCHIATObin board, the system should
reboot:
6/7
