MacAllister MWDV16L, Instruction And Safety Manual

Page: 8 / 142

EN
7
assembly removed from the tank, place the tank upside down so that the base is facing upwards.
Assemble the feet and the castors according to the following instructions for your model.
CASTOR SYSTEM ASSEMBLY
Remove all of the straps holding the castor feet together.
1. Facing the tank’s vacuum port, take castor feet marked A.
2. Insert the castor foot stem into the sockets also marked A, located on the front left and rear
right of the tank.
3. Make sure that the castor feet are fully inserted into the tank base and attach using the screws
supplied.
4. Take the castor feet marked B.
5. Insert the castor foot stem into the sockets also marked B, located on the front right and rear
left of the tank.
6. Make sure that the castor feet are fully inserted into the tank base and tighten using the screws
supplied. Turn the tank right side up and replace motor assembly.
Attach the hose to the vacuum port located on the tank.
The extension tubes slide one inside the other. Twist the extension tubes to lock them in place.
Attach the extension tubes to the accessory end of the hose.
Install the cleaning accessories (as needed) onto the end of the extension tubes.
Insert the power cord plug into a wall socket. You are now ready to use your vacuum cleaner.
Operation
WARNING : If the vacuum cleaner accidentally tips over, the shut-off float mechanism may cover
the joint and stop the suction. If this happens, simply stand the vacuum upright and turn it off until
the float returns to its normal position.
A
A
A
A
A
A
A
B
B
B
B
B
A
A