MACTOOLS.COM
4
4 - FIND MY LIGHT FUNCTION
•
When you want to find a light that has been misplaced, press the dock
call button for 2 seconds. Release when you hear 2 beeps. Afterwards,
the light will flash and the light alarm will activate.
•
Press the power button on the light to turn the alarm off.
5 - OUT OF RANGE FUNCTION
•
When this function is active, if the light gets too far from the dock, the
connection will break. This will cause the dock and light alarm to activate
and the light to flash.
•
To stop the alerts, press the dock and light buttons or return the light to
the dock.
•
By default, the Out of Range Function is deactivated on the light.
- To activate, press the light power button for 5 seconds and release
after you hear 2 short beeps. The function is active if you hear 2
long beeps.
OUT OF
RANGE
?
3 - PAIRING
•
Once the channel is set, you must pair the light to the dock.To do this
press the dock call button and the light power button for 10 seconds,
simultaneously.
Release the button after you hear 3 beeps.
•
After releasing, if you hear :
- 2 beeps : Pairing succesful
- 5 beeps : Pairing failed, repeat this step.
GETTING STARTED
1 - CHANNEL (CHN) SET UP
• If you are only using 1 light in a location, the channel is already set and you can skip this step.
•
If you have multiple "Find My Light" products in the same location, you must set different channels
for each product. To set the channel, find the dock switches on the back of the light and set each
light to a different switch configuration, using only the six combinations shown here,
Please note : Due to the number of available channels, the maximum number of lights in one location
is 6. If there is more than one product on the same channel, the location features won't work properly.
#1
#3
#2
#4
#5
#6
2- PLUG IN
•
Plug the dock into a 120VAC wall receptacle.
•
By default, the light is in hibernation mode and you'll need to activate
it. After plugging in the dock, wait for the red LED on the dock to
start slowly flashing or for the dock to beep (stop it with the button).
Afterward, charge the light for a few seconds to activate it. If the light
doesn’t activate, repeat the process from the beginning.
•
Be sure to charge the light every month if used infrequently to ensure
battery longevity.
