Model LFMR6
Installation, Operation, and Maintenance
File: LFMR6-IOM.doc
7
Rev:
2/22/08
Raising Vehicle
CAUTION
Most specialty or modified vehicles
cannot be raised on a frame engaging or pad
lift. Contact vehicle manufacturer for raising
or jacking details.
4. To raise lift:
A. Actuate
RAISE
switch on electric power unit.
B. Raise vehicle until tires clear floor.
3.
Before lifting the vehicle be sure that:
C. Check to make sure all four contact pads
are secure on the vehicle.
A. Individual axle weight of vehicle does not
exceed one-half lift capacity. See safety
instructions (capacity).
D. Continue to raise to desired height
ONLY
if
vehicle is secure on lift.
B. Vehicle is stable on lift and neither front
nor rear heavy.
E. Once you have reached the required height
set into lock by depressing the lowering
handle.
CAUTION
With some vehicles, the removal
(or installation) of heavy components may
cause a critical shift in balance and result in
vehicle instability. Refer to the vehicle
manufacturer’s service manual for
recommended procedures when performing
these services.
Lowering Vehicle
5. To lower lift:
Stand clear of lift and vehicle when
lowering.
Observe pinch point warning decals.
A.
Remove all tools or other objects from lift area.
B. Raise vehicle approximately 1” to
disengage lock.
C.
Push
LOWERING
valve handle to lower lift.
CAUTION
Lowering handle must be held
down to continue to lower lift. DO NOT
override self-closing lift controls.
6. Before moving vehicle, be sure lift is at the fully
lowered position and is clear of any tools or
objects.
NOTE:
The lock bar will reset automatically when the lift is
fully lowered or raised a minimum of 1”. If during
the lowering process the lift is stopped before it
gets to the fully lowered position. Reset by
repeating steps 5 or 6 from above.
