8
Attention! If you are unsure of the correct assembly of your rescue system ask
your dealer, or contact the MAC PARA importer in your country direct.
Assembly in outer container
1.
Place the Manix inner container with rescue canopy onto the outer container as
shown in the pictures below. The rescue canopy bridle leads to the tunnel on the right-
hand side. The line loop of the rescue canopy is placed in the tunnel on the right side.
Attention! Other placements can lead to malfunction of the system!
2.
You need 2 pieces of 50 cm spare line to place through the elastic loops on lateral
flaps. Thread this spare line through each elastic loop. This will help close the pocket.
Then lace the spare lines step by step through the bottom and followed upper front flap.
Thread the elastic loops into the smallest of the eyelets on the pocket flaps. Close the
flaps following the order shown in the photographs below. Push the metal pins on the
handle into the elastic loops. It is essential to remove the cords after this operation. The
cords should be pulled out slowly in order not to damage the elastic loops by excessive
friction. Finally, the handle should be positioned using the Velcro.
The Manix harness is ready for the reserve parachute container to be attached, using
the plastic buckles.
Correct assembly must be checked by a test release of the rescue system. If the system
is working then reassemble in the same way as described. When connecting the
reserve parachute to the harness, ensure that the parachute bridle passes outside the
harness' main attachment strap, relax bar and then leads to the rescue bridle.
Attention! Before each take-off check the locking pins securing the outer
container.
