Mac Mah W-UHF-Bodypack, User Manual, Page: 7 / 10

Operation of the W-UHF-Bodypack system
1/ Unpack all the components of the system. We recommend that you keep your
packaging.
2/ Connect the AC adapter to the power connector on the back of the receiver and
then to the power outlet to charge the internal battery.
3/ Then plug this receiver into the audio input of your speaker/console.
4/ Press the power switch on the receiver, the power indicator will light up.
5/ On the beltpack, open the battery compartment. Insert the batteries in the direction
shown.
6/ Turn on the beltpack, if the battery indicator light flashes, your batteries are ex -
hausted.
7/ Press the SET button for 10 seconds, you will see «...» appear on the microphone
screen.
Then, when the receiver is in the off state, press and hold the power button for 5
seconds and the RF signal light will flash green/red, indicating that it is entering the
matching mode.
When the RF light on the receiver stops flashing and turns green, the match is com -
plete. Press the SET button on the transmitter to exit the frequency match mode
Press the frequency control knob (CH+/CH-) on the transmitter to change the
frequency. Use a different frequency when using 2 or more microphones at one time.
1/ Frequency and channel used
2/ Frequency in MHz
3/ Battery status indicator
4/ MUTE status