When all the stop valves are connected and water
pressure is on, it is recommended that the supply
pipes are flushed to remove dirt and debris from
the water system
Before the flush valve is installed, open each
stop fully for 1 to 2 minutes.
Use a large bucket to catch the water
In multiple installations
start with the stop valve
closest to the city meter
Crown nut
Before the supply water is turned on, make sure all stop valves are closed tight.
To close the valve turn adjustment screw clockwise .
Stop Valve Installation
Solder sweat adapter onto existing
copper tube (if needed). Measure and
cut sleeve tube (if needed).
Slide flange and tube sleeve over pipe.
Fasten stop valve to sweat adapter or
pipe.
Fasten flange against the wall.
The outlet of the stop valve may be installed
to the left, or to the right side depending on
the placement of the toilet or the Urinal
Flange
Tube sleeve
Sweat adapter
Set screw
Allen wrench
System Flushing
Use sealing tape on the
male NPT threads ONLY
Stop valve
Adjustment Screw
Stop valve cap
4
1
2
3
4
