D
ESIGNE
D
&
A
SS
E
M
BLE
D
IN
T
H
E
US
A
Tab
Air Inlet Panel
866 558 3200 310 919 3073 Info@mac
fauc
ets.com www.mac
faucets.com
M
AC FAUCETS
Calif
ornia, USA
Place hands under sensor to activate.
Dryer will shut off a few seconds after hands are removed.
Daily Use and Maintenance
1. Remove Shell, see 06 above.
2. Open the air inlet panel, pull the air
filter out and clean it.
3. Install shell back on, see 06 above.
C
leaning cycle:
semi-annually or as needed
Connect the hand Dryer
05
Mounting instructions
04
Tighten the 2 countersunk screws on the shell.
Shell
Countersunk screws
Allen wrench
Hand dryers MUST BE
grounded to
avoid
personal injuries
All wire connections MUST BE conducted by an experienced electrical
contractor. Connect to an independent 20 Amp circuit braker.
NOTE: 110V ONLY
Grounding device
Knock
out hole
Wire
Connectors
Shell installation
External maintenance
06
01
Clean with a soft dry cloth
or towel.
Please use standard glass
cleaner ONLY.
Please DO NOT use harsh
solvents of any kind.
Using the wrong cleaning
tools or supplies will
cause damage to the unit
and finish and
WILL void
warranty.
Air filter maintenance
02
Operation instructions
01
Air filter
Sensing device
PAGE | 02
Electrical Box
6”-8” Long the
supply wire
Knock out hole
Install Electrical
Box inside
the wall
. Location is shown
in 02 page 1, point 2
Electrical Box must be
flush with the wall surface.
Pass the electrical cable
through the knock out hole
before mounting hand
dryer onto wall, leave 6”-8”
of wire inside of the hand
dryer.
Affix hand dryer onto wall
using the 4 supplied
screws, fasten securily
Use the wire
connectors provided.
Connect Black to Line, White
to Neutral, Green to ground
Connect the electrical
cable to the cable of
the hand dryer
(pre-installed)
L
B
N
W
G
G
L
B
N
W
G
G
Connecting hand dryer to
higher voltage will damage
hand dryer and
WILL void
warranty.
02
06
06
