42
43
MPS750S-2
MPS750S-2
In more detail...
In more detail...
EN
EN
device do the work, using the gripping teeth to apply minimal
leverage pressure.
10. Beware when reaching the end of the cut. The weight of the
product may change unexpectedly as it cuts free from the wood.
Accidents can occur to the legs and feet. Always remove the
product from a wood cut while it is running.
NOTE: The chain must be running at full speed before
it comes into contact with the wood.
Thin branches
Thin branches can be cut off with one single cut. To prevent the
branch from slivering and buckling the branch should be cut off in
several pieces (Fig. 33).
Fig. 33
Operation
Operation
Thick branches
When cutting off larger branches three cuts are necessary.
Fig. 34
Fig. 35
Fig. 36
1. First cut into the branch from below outside the place where you
intend to cut off the branch. The cut should go from one third to
halfway through the branch (Fig. 34).
2. Cut into the branch from the top outside at the same height the
branch is sawn from top (Fig. 35).
3. Last, cut off the stump with one clean cut from top to bottom (Fig.
36).
4. You might want to seal the cut with a suitable compound.
NOTE: Remove the branches lying on the floor
regularly to avoid stumbling hazards. Check the oil
level regularly and fill up if necessary. Switch the
power off and disconnect from power source when
leaving the product.
After use
1. Switch the product off, disconnect it from the power supply and let
it cool down.
2. Check, clean and store the product as described below.
