Mac Afric C0632C, Operation Manual

Page: 5 / 24

Max .
Rotary angle of tool post
Tool slide travel
Cr'6ss slide travel
Saddle travel
5. Tailstock
Dia , of taflstock quill
Taper of tailstock quill bore
Max.
Travel of lailstock qulll
6. Motor
Motor frequency
Motor power
Motor voltage
7. Lathe size and weight
Overall dimensions (LxWxH)
Net weight
Cross weight
HOISTING AND INSTALLATION
1 Finish removing the wooden crate from around the lathe
2. Unbolt the lathe from the shipping crate bottom.
9Cf
3 • (76mm)
5 118"(130mm)
34" (860mm)
1 114" (3.2mm)
M . T . N o . 3
4" C
1
00mm)
50/60 Hz
2HP(1.5KW)
220V/380V
1730X700X1285mm
3. Choose a location for the lathe that ls dry, has good lighting, and has enough room to be
able lo service the lathe on all four sides. The fixed dimension of the machine Is shown in Fig. _ _
4 . Sling lathe as shown In tl'le hoisting ct,art Fig. 1 when it is transporting. Wilh adequate
lifting equipment, slowly raise the lathe off the shipping crate bottom. Be sure that the suspension
rope is through space between three rods and bed
. Adjust the hoisting balance by sliding the
saddle . Make sure lathe is balanced before moving.
5. To avoid twisting the bed. the lathe's location must be absolutely Oat and level. Check for
a level condition I.Ising a machinist's precision level on the bed way both front to back and side to
side
6 . Clean all surfaces off anti-rust oll using .a mild commerci.al solvent. kerosene or diesel fue l
.
Do not use paint thinner, gasoline. or lacquer thinner. These will damage painted surfaces . Cover
all cleaned surfaces With a light film of 20# maohlne oil.
7 .
Remove the change gear
c o v er . Clean all components of the change gear assembly and
coat all gears with heavy, non-slinging grease Replace
c ove r .
. 2 .