12
OPERATING INSTRUCTIONS(continued)
If you plan to store the air conditioner during the winter, remove it carefully from the window
according to the installation instructions. Cover it with plastic or return it to the original carton.
Winter Storage
Never use water over 50 C, alcohol, gasoline, acid, solvent or
brush to clean the front panel as this will damage the surface of the part.
NOTE:
。
Never use harsh cleaners, wax or polish on the cabinet front.
Be sure to wring excess water from the cloth before wiping around the controls.
Excess water in or around the controls may cause damage to the air conditioner.
Plug in air conditioner.
The air filter behind the inlet grille should be checked and
cleaned at least once every 2 weeks (or as necessary) to
maintain optimal performance of the air conditioner.
Vertical air flow adjustment (manually)
Air Filter
How to remove the air filter
Turn off the unit, disconnect /unplug from the power supply.
1.
2.
3. Clean the filter with warm, soapy water. The water
should be below 40 C to prevent distortion of the filter.
4. Rinse off and gently shake off excess water from the
filter. Allow the filter to dry before replacing it. To prevent
distortion of the filter, do not dry in direct sunlight.
Hold the slot under the front panel, then uplift it outwards,
and remove the front panel.
Pinch the handle under the air filter and make the air filter
arched, remove it from the slot from underside to upside.
O
Cabinet Cleaning
Be sure to unplug the air conditioner to prevent shock or fire hazard. The cabinet
and front may be dusted with an oil-free cloth or washed with a cloth dampened in
a solution of warm water and mild liquid dishwashing detergent. Rinse thoroughly
and wipe dry.
NEVER operate the air conditioner without the
air filter, as dust/dirt particles can contribute to
equipment failure.
CAUTION
!
!
Airflow in vertical direction can be changed by adjusting horizontal louver
manually when the unit is running.
NOTE: Adjusting angle of horizontal louver depends on models.
To avoid generating condensing water on the surface of horizontal louver,
horizontal louver should not be at the maximum upwards or downwards
angle position for a long time in cooling or drying mode.