19
Thermostat
The thermostat is used to set the desired room temperature when
the unit is being operated in the COOL MODE.
To set the desired room temperature, rotate the thermostat switch
to the desired setting. After the set temperature is achieved the
thermostat will automatically start and stop the compressor in order
to maintain the desired set temperature.
Rotate the thermostat selector clockwise for higher cool settings.
Higher cool settings will provide lower room temperature. Rotate
the thermostat selector counter clockwise for lower cool settings.
Lower cool settings will provide higher room temperature.
Always wait 3 minutes when turning unit off then
on again, and when changing from cool to fan and
back to cool. This prevents compressor from over-
heating & possible circuit breaker tripping.
WARNING:
air directional louvers
The louvers will allow you to direct the air flow left or right
throughout the room as needed.
Move the center handle from side to side until the desired left/right
direction is obtained.