32
+
+
6
Connect
+
+
7
Disconnect
The connection socket consists of
A and B two parts. Before instal-
lation, A and B two parts must
be unscrewed about 5 mm, or di-
rectly disconnected. If the bore
of water tap is larger, remove
the plastic junk ring of part A.
To connect:
Push down the slide
jacket of speedy connector (4
small balls must be exposed), in-
sert it into the connection socket
and then push upward. Release
the connection of water tap with
speedy connector completely. If
it is required to feed water, sim-
ply open the water tap.
To disconnect:
Close the water
tap, push down
the slide jacket
of speedy con-
nector and pull
out the speedy
connector.
Firmly tighten the other end of the water inlet hose on the water in-
let valve (with the rubber seal inside).
NOTE:
When tightening the locking nut, apply an even force being
careful not to twist or break the water inlet valve.
Locking
Nut
Water
Inlet
Hose
WARNINGS:
• ALWAYS USE THE NEW INLET HOSES PRO-
VIDED WITH THE WASHER. DO NOT REUSE
PREVIOUS OR OLD INLET HOSES.
• THE APPLIANCE VENT HOLES SHOULD NOT BE
OBSTRUCTED BY A MAT OR CARPET.
• THIS APPLIANCE WAS DESIGNED FOR INDOOR
USE ONLY.
