Installation Tips
m
Measure the actual bathtub before building or modifying the
stud wall framework. The recommended measurements
are 3/8” wider and at least 3/16” deeper than the actual size
of the bathtub.
m
Turn off the hot and cold water supply during construction.
m
Never install our products directly on any surface that is or
may become, wet or damp.
m
Ensure all plumbing or electrical work inside the walls or
subfloor is finished prior to installation of the bathtub and
wall panels.
m
Make sure the drain hole in the subfloor or slab is large
enough (6” diameter recommended) and aligns with the
hole in the bathtub.
m
Verify the overflow drain plumbing will correctly connect to
the bathtub.
m
Make sure the subfloor under the bathtub is level in both
directions. The bathtub must be level when installed.
Improper installation will void the warranty.
m
The subfloor under the bathtub must be free of dirt, film,
waxes, or any other residues.
Disclaimer
m
The information contained in this Installation Manual is
given free of charge. It is based upon technical data
which we believe to be reliable and is intended for use, by
persons having knowledge of this technical area, at their
own discretion and risk. MAAX assumes no responsibility
for results obtained or damage incurred from the use of this
material either in whole or in part by the buyer.
m
This manual will give you basic step-by-step instructions
for the installation of the product that will work in most
types of installations. If you have an installation application
that is not covered in this manual,
before beginning the
installation
, please call your local MAAX distributor or
contact MAAX directly for additional information about your
application.
m
Follow all installation instructions. Failure to follow these
instructions could result in personal injuries, water damage,
or other damage to floors, pipes, walls, or other portions of
your building or home.
6
Installation Procedure
