MA Medi, Manual

Page: 17 / 20

REASSEMBLING THE MEDI AIR PURIFIER
Reassembling the Medi Air Purifier is as simple as reversing the steps of
disassembly. Use the screws that were removed in the disassembly
process to re-attach any aspect of the unit you took apart. However,
there are a few things to keep in mind when reassembling the unit.
Front Turbine Grille
When reassembling the Front Turbine Grille, carefully align it with the
screw holes so as not to damage the two ionization needles at the top
center of the unit.
APCO Cell
For the APCO Cell, position the tabs so that they face the bottom interior
of the unit and slide the holes in the tabs over the two Screw Posts from
which they were disassembled. Now orient the APCO Cell with the
APCO Power Connecter Outlet and continue to slide the cell in until the
tabs lock into place.
Purification Plate
To reassemble the purification plate, carefully slide it back into the
Purification Plate slot. Be very gentle when re-installing the plate. Do not
force it into the slot as this could cause serious harm to your unit.
However, ensure the Purification Plate is fully inserted.
Filter Assembly
When re-installing the filter assembly, make sure the honeycomb layer is
facing towards the unit. Ensure you place the three membranes back into
the filter assembly in the correct order: Honeycomb, foam, then mesh.
See picture below. When standing behind the unit, the honeycomb layer
of the filter should face the back of the unit. Fit the filter assembly into the
tabs, ensuring that they are connected properly. Once properly seated,
screw the Filter Assembly back into place.
Rear Cover
To reassemble the rear cover, simply align it with the tabs and screw
back into place.
Power Cord
Re-conect the power cord to unit then plug it into a wall outlet. Now you
can turn the unit back on by pressing the Power button. The unit will
automatically set to Normal Mode.