FCC Statement
Any Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and(2) This device must accept any interference received, including interference
that may cause undesired operation. Exposure Statement Exposure Statement
Exposure Statement Exposure Statement Note: This equipment has been tested
and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled
environment .This equipment should be installed and operated with
minimum distance 20cm between the radiator& your body.
Press and hold the side power button for two seconds to start the device. Press
and hold for more than 6 seconds to turn off the device. Switch to the photo
mode through the Home screen, and the avatar that can be obtained through
the camera is displayed on the tft screen.The USB cable must be connected
when working, and the lithium battery is used for short-term storage to prevent
power failure
