Starting the router
1.1 Cable connection
1.
Mount a 2G, 3G or LTE
450, CDMA 450 SMA antenna
to the Antenna titled SMA-M
interface (according to the
module/router type).
In case of 4G router, use two
antennas.
2.
Insert
an
activated
data SIM card to the SIM
holder, placed the chip-side up
and the cutted edge towards to
inside and push until it sleeves.
3.
Connect UTP cable to the router Ethernet titled port. The other side of the cable must
be plugged to the PC’s Ethernet port.
4.
The DHCP service is turned off for the router Ethernet interface, by default.
Therefore, you have to configure an IP address for you PC, manually.
1.2 Starting the router
1.
Plug the 12V DC power adapter chord to the POWER interface, then plug the adapter
to the 230V electrical network.
2.
The router has a pre-installed system (contains uploaded firmware and system software). After
plugging the power adapter, the router begins to work, whereas its LED signals are showing
the current activity during the operation.
When power up the router, all the three LEDs will flashes once – as in case of restart.
Add for. e.g. the 192.168.127.10 IP address to your computer’s Ethernet interface for
connecting to the router.
(If you have the WiFi onboard version of the router, then you can configure your router
on WiFi (DHCP activated).
