12
The Size of Panel Cut(Mounting Place)
Making the Panel Cut (Mounting Size) per each XTOP Series according to below Table, Before
Install the Product.
Measure:[mm]
Model
X(Width) Y(Height)
Detail Model
Thickness
XTOP05 Series
158
126
XTOP05MQ/05TQ S type, E type
1.6~9.0
XTOP08 Series
222
168
XTOP08TV/08TS S type, E type
XTOP10 Series
295
229
XTOP10TV/10TS S type
XTOP10TV-E
260
202
XTOP10TV E type
XTOP12TS-S
306
247
XTOP12TS S type
XTOP15TX-S
355
286
XTOP15TX S type
XTOP04TW
121
95
XTOP04TW U type
XTOP07TW
199
128
XTOP07TW U type
Main Menu(SETUP MENU)
• Main Menu
It display TOP type and communication level, version, language, time and you can set it up. If you
want to change time or language, you have to touch the value.
Comm. Setup
It can set the parameters of Communication of COM1/COM2 Port, 2 Port(2Way) Communication.
N:1 Communication, Ethernet Communication. They should be same value with the parameter of
Target PLC.
Note) In case of communication by CPU Module, another word target PLC be set as Loader Protocol in the Target PLC List
of Project Information in XDesigner Plus, their value of communication setting are constant by each makers, so It is
impossible to change the value of above COM1/COM2 In this Comm. Setup Menu.
Setup
For setting the Product configuration, product have to be changed to the Main Menu Mode, In
this Main Menu user can set the value of Communication Setup/Diagnosis/System Information
and Set up. Below is the Setup Screen of Main Menu
In Setup Menu Screen, It can set the value of Power on Mode/Initial Screen Number/Screen Save
/Buzzer/Latch Address/Printer/Password/Touch Sensitivity/LCD Brightness and Contrast/Initialize all
setting.
