TYPICAL TOOLS REQUIRED: measuring tape, std slot or phillips screwdriver, 11/32, 7/16, and 1/2
spin-tite, end wrenches and / or sockets.
1. Lay out the boom sections and assemble using the DIMENSION sheet as a guide for position and
hardware.
2. Lay out the elements by length and position as shown the DIMENSION sheet. Find rough center of
the reflector (longest) element by balancing it across finger. Push on a black button insulator to about
1/2” from center. Insert the element through the holes at the rear of the boom and install the second
button. Install the 3/16” rod DRIVEN ELEMENT as you did the reflector. Then continue with the
installation of the DIRECTORS.
Note that the Director Elements may not consistently diminish in
length from rear to front, so pay close attention to length and position specified on Dimension
Sheet.
3. Now begin centering the elements. Use a tape measure to EQUALIZE the amount the element
sticking out on each side of the boom. Once all are centered, sight down the antenna from the rear
and compare tip symmetry. Look for any obvious discrepancies and correct if found.
4. Stainless steel SHAFT RETAINERS are used for securing the elements and insulators. Always use
for permanent and long term antenna installations. For most portable or temporary use, the button
insulators are satisfactory and the retainers may
be left off.
5. Use thumb and index finger to hold a Shaft
Retainer over end of the 3/8 x 3” push tube
(internal fingers dished into tube). Hold the
element firmly and start the keeper onto the rod
by applying pressure with the push tube. Push the
Shaft Retainer down element until tight against
the button insulator (Locking pliers,
lightly
clamped up against opposite button insulator will
help maintain center reference and keep you from
pushing the first Shaft Retainer too far). Repeat
432-6WL ASSEMBLY MANUAL
Summary of Contents for 432-6WL
Page 4: ...432 6WL DIMENSION SHEET...
