38
ATTACHING AND REMOVING STROLLER CONVERSION KIT
The jogger conversion kit consists of a push bar and front wheel assemblies
that attach to the trailer to convert it to walking use. Install the push bar by
inserting ends into frame and pushing down until locking devices snap into
place.
Insert the front wheel into the bracket on the bottom of trailer and securely
tighten the knob. Attach the wheel axle to the front fork and insert the safety
brackets in the holes. Tighten and close the quick-release. When
completed, spin the tire to ensure it rotates properly before using.
To remove the front wheel, operate it in the opposite order. The conversion
kit can be placed in the rear compartment.
USING THE HAND BRAKE AND WRIST STRAP
The jogger/stroller is equipped with a hand brake to slow down the speed
and to park the vehicle.
The push bar is equipped with a locking clip for enhanced parking
performance. Pull back and engage the stamp brakes and clip the hook
onto brake bar to lock the stamp brakes in place.
Gently push on the vehicle to ensure the parking devices are engaged
before loading or unloading passenger or cargo
.
The brake cable may have weak tension and the brake can not properly work. It
should need a fine-tuning on the tension nuts. The cable tension can be tuned
via the red tension nuts. Adjust the opposite side of tension nuts by turning
down to proper
position and then turning up the upper nut to fix the lower nut. When completed,
test the stamp brakes to ensure it work properly before using.
