M.T.H. N6b Instruction Manual Download Page 4

OTS OPERATION (CONT.)

Hold the OTS switch in the "Unload" position for 2 seconds (Refer to your OTS instruction 
sheet for complete directions in its use.)  The caboose will automatically cycle. A  signalman 
will come out with a lantern, then will go back to the rear of  the caboose, ending the cycle.  
Press unloading switch again to begin another cycle.

CAUTION: ELECTRICALLY OPERATED PRODUCT:

 

WARNING:

 When using electrical products, basic safety precautions should be observed, including the following:

Read this manual thoroughly before using this device.

l

M.T.H. recommends that all users and persons supervising use examine the hobby transformer and other electronic equipment periodically for 

conditions that may result in the risk of fire, electric shock, or injury to persons, such as damage to the primary cord, plug blades, housing, output 
jacks or other parts.  In the event such conditions exist, the train set should not be used until properly repaired.

l

Do not operate your layout unattended.  Obstructed accessories or stalled trains may overheat, resulting in damage to your layout.

l

This train set is intended for indoor use.  Do not use if water is present.   Serious injury or fatality may result.

l

Do not operate the hobby transformer with damaged cord, plug, switches, buttons or case.

Recommended for Ages 14 and up.  Not recommended for children under 14 years of age without adult supervision.  As with all electric 
products, precautions should be observed during handling and use to prevent electric shock.

Summary of Contents for N6b








Reviews: