21
MTH Blue Comet Operating Manual
PREMIER
LINE
Feature 45. (See the section Using RESET To Program ProtoSounds on
page 18). Once in Feature 45, press the whistle button and wait for the
module to sound a bell ding(s). Continue pressing the whistle button until
the module plays back two dings for option 2 - Squeaking brakes on all the
time, subject to throttle movements. Press the whistle button again until the
module plays back three dings for option 3 - Squeaking brakes off. Once
you have decided on the
desired setting, simply
turn the throttle off and
then on again to “Lock-
In” the new setting. To
reset the computer to its
original factory default
setting (option 1 -
squeaking brakes
activated by bell button controller, repeat the above procedure but keep
pushing the whistle button until the module only responds with one bell
ding.
PROGRAMMING FOR WHISTLE IN NEUTRAL
OPERATION
If you are operating your engine with a separate bell button and want to
blow your horn when your engine is in neutral, you will need to program
ProtoSounds to do so as the factory setting only allows the horn to blow in
forward or reverse. To do this, enter RESET and go to Feature 25. (See the
section Using RESET To Program ProtoSounds® on page 18.) Once in
Feature 25, press the transformer whistle button and wait for ProtoSounds
to sound a bell ding(s). Continue pressing the whistle button until
ProtoSounds sounds two bell
dings (signifying that
ProtoSounds has been
programmed to sound the
horn in neutral). Turn the
throttle off and then on again
to “Lock-In" your selection.
Now, whenever you are in
neutral, you can blow the
horn with the transformer
Clank,
Clank,
Clank,
Clank,
Clank,
Etc.
In RESET Mode
Move The Throttle
Up & Down From
High Voltage To Low
25 Times
Listen For 5 Clank
And 0 Clink Sounds
Push The Whistle Button
Until You Hear
2 Bell Dings
Interrupt The Throttle
To “Lock-In”
The Volume Setting
H
Clank,
Clank,
Clank,
Clank,
Clank,
Etc.
In RESET Mode
Move The Throttle
Up & Down From
High Voltage To Low
45 Times
Listen For 9 Clank
And 0 Clink Sounds
Push The Whistle Button
Until You Hear The
Appropriate # Of Dings
Interrupt The Throttle
To “Lock-In”
The Volume Setting
H