R1D-GH2
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: [email protected]
EM-5958 Rev.7 P. 2 / 5
COMPONENT IDENTIFICATION
■
TOP VIEW
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18
19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 35
CAN_H
V+
Drain CAN_L
V–
T6 T7 T8
CJC Sensor (model: CJM)
■
REAR VIEW
A
H
B
C
D
G
F
E
I
NAME
FUNCTIONS
A
Power terminal block
For power input
B
Network terminal block
For wiring to DeviceNet
C
Baud rate setting
125, 250, 500 kbps (factory set to: 125 kpbs)
D
Node address setting
Selectable within 00 – 63 (factory set to: 00)
COLOR
FUNCTIONS
E
NS (Network Status)
indicator LED
Red
ON:
Critical communication error
Blinking: Minor communication error
Green
ON:
Communication established
Blinking: Communication down
----
OFF:
Power Not supplied
COLOR
FUNCTIONS
F
MS (Module Status)
indicator LED
Red
ON:
Critical failure
Blinking: Minor failure
Green
ON:
Normal conditions
Blinking: Device Not configured
----
OFF:
Power Not supplied
COLOR
FUNCTIONS
G
Power LED
Green
ON:
Power supplied
----
OFF:
Power Not supplied
H
Configurator jack
2.5 dia. miniature jack; RS-232-C level
I
Specifications
Display(s) serial No., model No., etc.
INSTALLATION
■
DIN RAIL MOUNTING
Set the body so that its DIN rail
adaptor is at the bottom. Pull
down the DIN rail adaptor.
Position the upper hook at the
rear side on the DIN rail and
push in the lower. Push back the
DIN rail adaptor.
■
WALL MOUNTING
Set the body so that its DIN rail
adaptor is at the bottom. Pull
down the DIN rail adaptor.
Refer to “EXTERNAL DIMENSIONS.”
DIN Rail Adaptor
DIN Rail
35mm wide
