If one of program monitor lights is on and start/Pause light is on and off,
Your machine’s door is open, shut the door.
If the programme won’t start
•
Check if the plug is connected.
•
Check your indoor fuses.
•
Be sure that the water inlet tap is turned on.
•
Be sure that you have closed the machine door.
•
Be sure that you switched off the machine by pressing the Power On / Off button.
•
Be sure that the water inlet filter and the machine filters are not clogged.
If the lamps “Wash/Dry” and “End” keep flashing
•
Water overflow alarm is active
•
Turn off your tap and contact an authorised service.
If the control lamps won’t go out after a wash operation
The
Power On/Off
button is released yet.
If detergent residues are left in the detergent compartment
Detergent has been added when the detergent compartment was wet.
ERROR CODE
Wash / Dry
End
Start/Pause
ERROR
DESCRIPTION
CONTROL
Inadequate water
supply
•
Make sure the water input tap is totally open and that
there is no water cut.
•
Close the water input tap, separate the water input
hose from the tap and clean the filter at the connection
end of the hose.
•
Restart your machine, contact the service if the error
resumes.
Error of continuous
water input
•
Close the tap.
•
Contact the service.
The waste water in
the machine cannot
be discharged.
•
Water discharge hose is clogged.
•
The filters of your machine might be clogged.
•
Power off-on your machine and activate the program
cancellation command.
•
If the error continues, contact the service.
Intended water
temperature could not
be reached faulty
heater and heater
sensor
Contact the service.
Alarm is active against
water overflow
•
Power off your machine and close the tap.
•
Contact the service.
Faulty electronic card
Contact the service.
FAILURE CODES AND WHAT TO DO IN CASE OF FAILURE
23
