M2PRU
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: [email protected]
EM-5076 Rev.8 P. 2 / 4
■
FILTER
• The M2PRU is designed to accept at the maximum of 100
kHz, which may cause errors due to chattering in the in-
put pulses.
A filter circuitry (time constant: approx. 1 msec.) is in-
corporated to eliminate unwanted chattering when the
mechanical contact input is specified. It is effective for
most relay types, however, an external CR filter as indi-
cated below, could be added if the user need improvement.
Limit the input frequency to 10 Hz at maximum.
C
+
‒
Relay
R
PULSE
SCALER
C = 100 µF
R = 100Ω
COMPONENT IDENTIFICATION
Model
Body
Base Socket
Pulse Sensing
Type Selector
Connection
Diagram
Specifications
Fixing Screw
INSTALLATION
Loosen the fixing screw at the front of the unit in order to
separate the body from the base socket.
DIN Rail
35mm wide
Spring Loaded
DIN Rail Adaptor
■
DIN RAIL MOUNTING
Set the base socket so that
its DIN rail adaptor is at
the bottom. Position the
upper hook at the rear side
of base socket on the DIN
rail and push in the lower.
When removing the socket,
push down the DIN rail
adaptor utilizing a minus
screwdriver and pull.
■
WALL MOUNTING
Refer to “EXTERNAL DIMENSIONS.”
TERMINAL CONNECTIONS
Connect the unit as in the diagram below or refer to the connection diagram on the side of the unit.
■
EXTERNAL DIMENSIONS unit: mm (inch)
5
9
21.5 (.85)
70.5 (2.78)
86.7 (3.41)
7.3 (.29)
15 (.59)
6 (.23)
59 (2.32)
DIN RAIL
35mm wide
[4 (.16)]
8–M3
SCREW
72 (2.83)
23 (.91)
2–4.2x5
(.17x.20)
MTG HOLE
6 (.24) deep
116.7 (4.59)
• When mounting, no extra space is needed between units.
1
4
8
12
14 13
4 (.16)