M6SPA
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: [email protected]
EM-7974 Rev.5 P. 3 / 4
■
CONNECTION DIAGRAM
1
2
+
2.4 kΩ
–
2.5 V
+
–
+
–
OUTPUT
5
6
+
–
INPUT
1
2
■
Open Collector or
Mechanical Contact
Input Connection Examples
■
Voltage Pulse
1
2
+
–
8
7
POWER
CONNECTOR
POWER
■
WIRING INSTRUCTIONS
• Applicable wire size
Solid: 0.2 to 2.5 mm
2
(0.55 to 1.75 dia.)
Stranded: 0.2 to 2.5 mm
2
(Tinning wire ends may
cause contact failure and therefore is not
recommended.)
Ferruled: 0.2 to 1.5 mm
2
(0.55 to 1.35 dia.)
• Expose wire conductors by 8 mm (0.31”).
Expose 8 mm
• How to Connect Wires
Screwdriver
Wire
1) Insert a minus screwdriver into the wire entry opening,
between the clamp and the housing, until its tip hits the
bottom where it is firmly held.
Tension Clamp
Screwdriver
2) Insert a wire. Push the screwdriver toward the direction
indicated with the arrow in the figure below to widen the
opening if necessary.
Wire Entry
Wire
3) Confirm that the wire tip hits the bottom and pull out the
screwdriver in holding it in position.
Confirm that the wire’s insulation tube is not caught in
the clamp.
